ADG Solutions

T-Cleaner

Pre-Separate dust from flakes to maximize your quality

The T-Cleaner separates “the bad” from “the good”. Operating inline on your material flow, the T-Cleaner separates the undesired materials (like dust) from the acceptable ones.

The selection is done by means of specific weight of the passing material.

A finer tuning can be done accepting “more” or “less” light materials just operating a handle.

The lighter materials comes out from the top exit while the heavier material exits from below.

The maximum througput is 6600 lbs/h (3000 kg/h).

This picture shows a typical result of a material separation by a T-Cleaner. In this case the lighter flakes are completely separated from the good ones.

The application can be reversed. The T-Cleaner can be used to remove heavy materials (like stones) from the good ones, using the top exit as clean exit one and the one on the bottom as waste exit.

Please wait while flipbook is loading. For more related info, FAQs and issues please refer to DearFlip WordPress Flipbook Plugin Help documentation.

This is one example of line setup, with the discharge of light dusts collected by a blower and a cyclon.

On the bottom any means of conveyor can be installed (blower, vacuum, auger, belt, …).

This is one example of line setup, with the discharge of light dusts collected by a blower and a cyclon.

On the bottom any means of conveyor can be installed (blower, vacuum, auger, belt, …).